again it’s always awkward telling people this but I mean no offense
it’s kinda a mess of a stickfigure, as in there’s a lot of stuff going on but overall it looks like a stickfigure with some stuff sticking out here and there, and red lines shooting all over
then the front version, the eyes aren’t even symmetrical, etc, things like that I notice when going through packs (many packs and stickfigures, not just yours) and they just don’t check enough boxes to get approved/uploaded
clean him up a bit and resubmit
they’re not far off from being good but there’s just too much eh where, you know, that’s just why it wasn’t approved
Replying to:Ralph (Developer)yeah I got that, I just redownloaded and checked
again it'
It’s fine I understand I’ll try to fix it and it’s hard for the eyes to be symmetrical when you can’t copy poly fills which is what I used for the eyes of it
yeah I got that, I just redownloaded and checked
again it’s always awkward telling people this but I mean no offense
it’s kinda a mess of a stickfigure, as in there’s a lot of stuff going on but overall it looks like a stickfigure with some stuff sticking out here and there, and red lines shooting all over
then the front version, the eyes aren’t even symmetrical, etc, things like that I notice when going through packs (many packs and stickfigures, not just yours) and they just don’t check enough boxes to get approved/uploaded
clean him up a bit and resubmit
they’re not far off from being good but there’s just too much eh where, you know, that’s just why it wasn’t approved
It’s fine I understand I’ll try to fix it and it’s hard for the eyes to be symmetrical when you can’t copy poly fills which is what I used for the eyes of it
P.S and I’m still new to creating stickfigures so I’m gonna have bad ones
P.S.S Did you disapprove my trophy too?